CP-4A Lens Cutter, simple lens edger

 Features:
* Quick speed lens cutter.
* Cut CR lenses which are below 1.61
* Imported milling cutter
* With a knob to control the size of lens to cut.
* Net weight:  5kg.
* Accessories:  3pcs of sucker（Topcon,Briot and Takubo）,1pc of rubber chuck and 1pc of brush.
* Produce size:  34*31*19cm.

Operation procedure:
* Put lens template to template position, clamping it by the right knob.
* Put a lens which has been marked the axis on lens meter and layout blocker into the position of lens and then fix it by the left knob.Waiting for cutting.
* Power on,put down the machine head lightly. Make the lens on the middle position of milling cutter.
* Lift up the machine head after turning a circle. Take off the made lens carefully.
* Then finishing it by hand Lens Edger is ok.

Notice:
* Except lens cutting,please don’t use it in other things.
* Please don’t touch milling cutter when the machine is working,avoid to be hurt.
* When voltage and frequency can’t meet the requirements,please don’t use the machine, you should be sure of situation of power supply.
* Don’t put machine in position with high temperature or direct sunlight.
* If any liquid or material is inside the machine, please turn off the machine immediately, and then pull out the plug.
* It can be used until checked and repaired by professional people.
* Except original components,please don’t install other accessories.
* Please don’t make machine overload,don’t collide any component of the machine.
* Please pull out the plug if you don’t use the machine for a time.